When fishing in domestic reservoirs, senior fishing friends will use canoes. We need to pay attention to four points.
- Kayak Casting For ease of casting from a kayak, an anchoring system can be installed. Install a pulley near each end of the kayak, and then put on a nylon braided rope. The ends of the rope are bound to a strong metal or plastic ring, threaded into the anchor line and tied to the deck. Use the pulley rope to move the wheels forward and back to adjust the anchor point until the kayak is at the target fishing spot and casts freely.
- Avoid river obstacles When two people are rowing down the river, the best way to avoid danger is to row the bow of the boat to the left and right. The paddlers at the stern row the paddles mainly to support the hull of the canoe stably, so that the hull runs in line with the paddling rhythm of the paddlers at the bow, and when the boat is in a dangerous area, it can be stabilized, and it can be rowed forward vigorously to Avoid emergencies.Also read:best fishing kayak under 1000
- Change the load and adjust the paddle power. When the boat is traveling against the wind, the load should be adjusted so that the canoe is slightly head-heavy. The leading edge of the bow sinks deeper into the water, making the boat less prone to drifting off course due to headwinds. And the slightly lighter stern moves forward with the wind. If sailing downwind in open water, the opposite is true and the load should be towards the stern. You don't need to constantly correct your course when the wind is on the stern.
- Put the canoe on the roof rack
- Turn the bottom of the boat up, and buckle the center of gravity of the bow and stern on the frame in reverse. Each vehicle frame fastens the hull with a triangular buckle fixing belt. Do not cross-tie, be sure to tie the binding strap directly against the side of the ship through the fixing bracket.
- Tighten the bow of the boat with two ropes, and tie the other end of the rope to the stern. Please do not use the same rope strap or rope to make a long V-shaped anchor point.
- Hold the drill bit up, down, left and right and shake it vigorously to check whether it is firm. Make sure that the boat does not move when the car shakes. In the same way grab the stern to check. It is necessary to stop and check the reinforcement after driving for 10 minutes to ensure safety.
For more information, please visit:YeaPei